GE Vivid q N - Page 98

GE
D
IRECTION FQ091019, REVISION 2 VIVID Q N SERVICE MANUAL
3-26 Section 3-7 - Completing the Hardware Installation
3-7-1-2 HP470 Color Printer
The DeskJet Color Printer connection in the different scenarios is explained below.
• Connection via LAN
There are a few DeskJet Color Printers that can be connected to the system via LAN - refer to "Add
Printer" on page 3-80. The DeskJet Color Printer can be connected to an external, non-isolated
power source.
No SafeLock Cart - connection directly to the Vivid q N system
This only applies to HP 460 models which are supplied pre-installed with the appropriate software
drivers. The DeskJet Color Printer can be connected to either of the USB ports (upper or lower) on
the rear connectors panel.
When connecting directly to the system it is necessary to use an additional power source. As a
safety precaution, this must be done via an isolation transformer.
The DeskJet Color Printer can be connected once the system is powered ON, or after shutdown.
NOTICE
IMPORTANT
Do not connect the DeskJet Color Printer to the Vivid q N system while scanning is in progress!
NOTICE
IMPORTANT
During Stand-by mode, it is NOT recommended to introduce or remove USB devices; this may
cause the system to lock-up during the boot-up procedure.
Figure 3-18 DeskJet Color Printer
WARNINGWARNING
Do not attempt to use a different type of DeskJet Color Printer (brand or model) other than the
DeskJet Color Printer provided by
GE. The ultrasound system is an extremely sensitive and
complex medical system. Any unauthorized peripherals may cause system failure or damage!