180 ADV200 • Quick start up guide
10.7 Wiring connection using SBM motor series
Drive/Feedback connections
Following paragraphs specify the connection between the drive ADV200 and sen-
sors feedback installed on SBM standard series synchronous motors.
10.7.1 Resolver wiring (RES)
Following table shows the connections needed using Resolver sensor mounted on
SBM5, SBM7, SBM8, SBM9 Gefran series motor:
Resolver
19poles SBM motor connector
SBM5, SBM7, SBM8, SBM9
EXP-RES-I1R1-ADV board
A
B (SHIELD) Drive side
C resolver cos+ channel 23
D resolver cos- channel 24
E resolver sin - channel 22
F resolver sin+ channel 21
G
H
J
K
L
M
N
P
R
S (KLIXON) Klixon contact Note 1
T (KLIXON) Klixon contact Note 1
U Excitation resolver + 25
V Excitation resolver - 26
Resolver
10poles SBM3 motor connector EXP-RES-I1R1-ADV board
A
B (SHIELD) Drive side
C resolver cos+ channel 23
D resolver cos- channel 24
E resolver sin - channel 22
F resolver sin+ channel 21
G Excitation resolver +
H Excitation resolver - 26
J (KLIXON) Klixon contact Note 1
K (KLIXON) Klixon contact Note 1
- For resolver cable use twisted pair shielded cable; the pairs should be the signal wires cos+/cos-,sin+/
sin-, exc+/ exc-, motor temperature sensor wires. All the shields must be connected together to cable
shield pin of resolver connector on the motor side and on drive side.
Note 1 : “Klicson” Motor thermal contact can be connected to a digital input of the drive programmed as alarm
Motor Overtemperature, [12] Motor OT.
Menu: 24 - ALARM CONFIG
IPA Description Note Default
4520 Motor OT src Digital input selection Zero
4522 Motor OT activity Alarm type selection Fast Stop
4528 Motor OT holdoff Digital filter setting 1000ms
To Next Page
Loading...
Need help?
General
