HAPTER
1
INTRODUCTION
The information in this Operator's Manual was written to give the owner/operator assistance in preparing, adjusting,
maintaining and servicing
of
the Loader. More importantly, this manual provides an operating plan for safe and proper
use
of
the machine. Major points
of
safe operation are detailed in the
SAFETY
chapter
of
this manual. A chart
of
standard
hardware torques
is
located in the back
of
this manual.
The
GEHL
Company
asks
that
you
read
and
understand
the
contents
of
this
manual
COMPLETELY
and
become
familiar
with
your
new
machine,
BEFORE
attempting
to
operate
it.
Throughout this manual, information
is
provided which is set in italic type and introduced by the word
NOTE.
Be sure
to read carefully and comply with the message or directive given. Following this information will improve your operating
or maintenance efficiency, help you to avoid breakdowns or damage and extend your machine's life.
A plastic container
is
provided on the unit for storing the Operator's Manual. After using the Manual, please return it to
the container and keep it with the unit at all times!
If
this machine
is
resold, GEHL Company recommends that this
Manual be given
to
the new owner.
"Right" and "left" are determined from a position sitting on the Seat and facing forward. From this position:
If
your
Loader is T-Bar Controlled: the Propulsion (Traction) Control T-Bar is on the "left" and the Liftffilt Control
T-Bar
is
on the "right".
If
your
Loader is Hand/Foot Controlled: The "left" T-Bar controls the Propulsion (Traction) on the left side
of
the
machine. The
"right"
T-
Bar controls Propulsion (Traction) on the right side
of
the machine. The "leji" Foot Pedal controls
the Lift. The
"right" Foot Pedal controls the Tilt.
Our wide Dealership network stands by to provide you with any assistance you may require, including genuine
GEHL
service parts. All parts should be obtained from or ordered through your GEHL Dealer. Give complete information about
the
PaIt and include the model and serial numbers
of
your machine. Record the serial number in the space provided on
the previous page, as a handy record for quick reference.
GEHL Company reserves the right to make changes or improvements in the design or construction
of
any part without
incurring the obligation to install such changes on any unit previously delivered.
2
The GEHL Company,
in
cooperation
with
the
American
Society
of
Agricultural
Engineers and
the
Society
of
Automotive
Engineers,
has
adopted
this
SAFETY ALERT SYMBOL
to
pinpoint
characteristics
which,
if
NOT
properly
followed,
can create a
safety
hazard. When
you
see
this
symbol
in
this
manual
or
on
the
machine
itself,
you
are reminded
to
BE ALERT! Your
personal
safety
is
involved!
To Next Page
Loading...
Need help?
General
