CHAPTER
10
TROUBLESHOOTING
The following Troubleshooting Guide lists potential prob-
lems,
as
well
as
possible causes and remedies, for Gehl Skid
Loaders.
A
CAUTION
When a problem occurs, don't overlook simple causes. A
malfunction could be caused
by
something
as
simple
as
an
empty Fuel Tank. After a mechanical failure has been cor-
rected, be sure
to
locate the cause of the problem.
DO NOT attempt to service or repair
major
components, unless authorized to do so by
your GEHL Dealer. Any Unauthorized Repair
will Void the Warranty.
ELECTRICAL SYSTEM
PROBLEM
POSSmLE
CAUSE
REMEDY
Entire Electrical Battery Disconnect Switch is "OFF"
Turn Battery Disconnect Switch to
System does not
(optional feature).
"ON".
function.
30 ampere (Master) Fuse, is blown.
Refer to the wiring diagram, check
circuit and locate trouble (i.e., pinched
wires, faulty connections, etc.) before
replacing Fuse.
Main Wiring Harness Connectors at
Check Main Connectors.
rear
of
Overhead Guard are not
properly plugged-in.
Battery Terminals or Cables are loose
Clean Battery Terminals and Cables and
or corroded.
retighten them.
Battery is faulty.
Test Battery and replace as needed.
No
Instrument Panel 30 ampere (Master) Fuse or 20 ampere
Refer to the wiring diagram, check
lamps with Keyswitch Fuse is blown.
circuit and locate trouble before
turned
to
"ON".
replacing Fuse(s).
Battery Terminals or Cables are loose
Clean Battery Terminals and Cables and
or corroded.
retighten them.
No Glow Indicator Bulb is burned out.
Replace Bulb.
Lamp with Key Switch
turned to "ON".
Faulty QGS Module.
Contact your Gehl Dealer for assistance.
Buzzer does not sound Buzzer
is
disconnected.
Reconnect Wires to Buzzer.
when Key is first
turned to "ON", Faulty Buzzer. Replace Buzzer.
indicator lamps work
properly.
Fuel Gauge does not
Faulty Fuel Gauge Sender.
Replace Fuel Gauge Sender.
work.
Loose wiring/terminal connections.
Verify wiring connections.
Faulty Fuel Gauge.
Replace Fuel Gauge.
49
To Next Page
Loading...
Need help?
General
