Gehl 5625SX User Manual

Service Every 100 Hours
CHECK PLANETARY GEARCASE
OIL LEVEL (Fig. 39)
Each Planetary Gear-case contains approximately
quart (0.9 liter)
of 80W90 oil. An Inspection Fill Plug
is provided on each Gear·case for oil checking and
refilling. Unbolt roll-back and Lock the ROPS and
remove the Operator's Compartment Floorplate to
gain access to the Plugs. Add oil through the Inspection
Fill Plug until it just begins to flow from the Plug.
CHANGE ENGINE OIL & FILTER
(Fig. 36)
5625 Models are equipped with a remote Oil Filter
which is located under the Engine Cover on the right
hand side. Access for draining the Engine oil is gained
by removing the Bellyplate Cover.
Access for adding new oil is obtained by opening the
Engine Cover. Refer to the Lubrication Chapter in this
manual for oil recommendations and quantity and to
the separate Engine manual for Oil Filter and oil
changing procedure.
A
Spin-on Oil Filter Element can be obtained by
ordering the following GEHL part number: 127389.
CLEAN SPARK ARRESTOR MUFFLER
(Fig. 36)
NOTE: This Loader is factory equipped with a
V.S.D.A. Forestry Service approved Spark
Arrestor Muffler. It is necessary to do
maintenance
on the Muffler to keep it in working
condition. Make reference
to local laws and
regulations for spark arrestor requirements.
To clean the Muffler, open the Rear Grill and open the
Engine Access Cover. Loosen the front Muffler Clamp
and remove the rear Clamp and Muffler. Dump the
contents from the spark chamber and then reinstall
Muffler. Check that the Muffler Clamps are secure
and, after starting the Engine, that the exhaust system
is quiet and NOT leaking.
62
Fig. 39: Planetary Gearcases
1. Inspection Fill Plug on Left Planetary Gearcase
CHECK ALTERNATOR/FAN BELT
TENSION & CONDITION
Refer to the Adjustments Chapter and the separate
Engine manual for setting proper Belt tension.
If the
Belt is worn, cracked or otherwise deteriorated,
replace the Belt following the procedure in the separate
Engine manual.
Replacement
Alternator Drive Belts can be obtained
by ordering the following GEHL part number: 128279.
LUBRICATE T-BAR PIVOTS
Refer to the Lubrication Chapter in this manual for
details.
To gain access to the fitting, slide the Rubber
Boot up.
TIGHTEN WHEEL LUG NUTS, CHECK
DRIVE CHAIN TENSIONS & CHECK OIL
IN CHAINCASES
Retorque the Lug Nuts to 150 ft-lbs (203 Nm).
Check Drive Chain Tension following the procedure
under the "Drive Chains" topic in the Adjustments
chapter
of this manual.
Each 5625 Drive Chaincase requires 2 gallons (7.6
liters)
of SAE lOW-30 multi-viscosity motor oil. (Fill
to approximately 1 1/2" deep).
This quantity
of oil should be maintained at all times.

Gehl 5625SX Specifications

General

Brand	Gehl
Model	5625SX
Category	Compact Loader
Language	English