Zoom | 48Settings
Single Axis Vertical angles refer to the plummet line.
Dual Axis Vertical angles refer to the plummet line and the
horizontal directions are corrected by the
standing axis tilt.
For corrections depending on the HA Corr:
setting, refer to the table "Tilt and horizontal
corrections".
)
If the instrument is used on an unstable base, for example a
shaking platform or ship, the compensator should be deacti-
vated. This avoids the compensator drifting out of it's meas-
uring range and interrupting the measuring process by indi-
cating an error.
HA Corr. On Horizontal corrections are activated. For normal
operation the horizontal correction should
remain active. Each measured horizontal angle
will be corrected, depending on the vertical
angle.
For corrections depending on the Tilt Corr:
setting, refer to the table "Tilt and horizontal
corrections".
Off Horizontal corrections are deactivated.
Field Description
To Next Page
Loading...
