GeoVision GV-EBD4813 - Page 67

54
1. Attach the GV-Mount213 to the wall / ceiling and use a marker to mark the location for
the center socket and the 3 screws.
Figure 1-77
Note: To prevent rain from getting into GV-ADR2701 / 2702 / 4701 / 4702 & TDR2702 /
2704 / 4702 / 4703 / 4704 / 4803 / 8805,
• For ceiling mount installation, turn the indicated hole inwards.
• For wall mount installation, make sure the indicated hole points down and towards the
ground.
Figure 1-78
2. Drill 3 holes according to the screw locations. Then, drill a bigger hole at the center
socket location for the Ethernet cable.