Window “F” + “5” shows position and measured conductivity from one
receiver. There is also displayed map of measured area in the window. Only saved
points are shown in the map. At the right side of the map there are scale [in meters]
and map orientation labels. The map is scrolled automatically so that the current
position is in the marked point in the center of the map.
Window “F” + “6” shows measured conductivities from three receivers and
in-situ two-layered 1D inversion (conductivity of the first layer, conductivity of the
bottom layer, thickness of the first layer and RMS error of the inversion). Only “-
1” values are displayed if the 1D inversion was not calculated successfully
(measured conductivities are out of range for inversion calculation – over 1000
mS/m, under 1 mS/m or too wide difference between measured conductivities).
Only the highest standard deviation (from three receivers) is displayed. This
window is available only if CMD-Explorer / MiniExplorer are used.
To Next Page
Loading...
