To Next Page

To Previous Page

ProfiLux 4 Programming Guide

EN 2017-02-06 18

the lower arrow key to count back. Once you have entered the desired number,

confirm with ->RETURN. Up to 150 dosages are possible, 0 = No dosage.

 Decide on which weekdays the dosages should take place or select the daily interval if

a dosing is to take place every day or every 2 days ... etc.

 Enter the Flow rate of the dosing pump ->RETURN

 Enter the dosing amount Rate per dosing ->RETURN

The dosing time points are calculated automatically (they are distributed evenly throughout

the day). The duration of the dosage is calculated automatically by means of the Flow rate of

the pump and the Rate per dosing (See below).

Manual dosing

 Set the number of doses per day. A maximum of 8 dosings per day are possible -

>RETURN

 Decide on which Days of week the dosages should take place or select the Interval of

days if a dosing is to take place every day or every 2 days ... etc. The maximum daily

interval is 200 days (see below).

 Enter the flow rate of the dosing pump ->RETURN

 Specify the time at which the first switching / dosing should take place

 Enter the dosing amount Rate per dosing ->RETURN

 Proceed with the further desired switching operations as with switching operation 1

There are as many switching cycles per day as was set at dosages per day before. The time

points of the dosage can be defined explicitly in the following. The switching time is

calculated automatically by means of the Flow rate of the pump and the Rate per dosing. (see

below).

If you have selected Automatic dosing, the first dosing of the day is usually made at 0:00. With

Always dose at (this time) you have the possibility to determine the time of the first dosing. All

other doses are distributed throughout the day

The following features are only available via GHL Control Center, Web Interface, App and cloud

service myGHL:

The dosing pump control has a level monitoring. When the pump is active ProfiLux 4

calculates the new filling level.

For this purpose, the Capacity of the container as well as the minimum amount must be

entered.

GHL ProfiLux 4 Programming Guide

Other manuals for GHL ProfiLux 4