To Next Page

To Previous Page

ProfiLux 4 Programming Guide

EN 2017-02-06 20

You can set the illumination run for each lighting individually. This makes it possible to

achieve effects like sunrise or moonlight.

3.1 Illumination Run

Please select which lighting is to be edited (Illumination to edit?). After selecting a lighting, you

can set the type of the luminaire, dimmable and non-dimmable.

It is also necessary to specify whether the automatic is to be switched on (Automatic on?). If

this is not the case, this lighting is in manual mode. Select whether you want a temperature-

dependent light reduction.

Enter the number of dim-points (for dimmable luminaires) or the switch-times (for non-

dimmable luminaires) for which you want to adjust the brightness (up to 24)

If you have selected a dimmable luminaire, please set the following for each dim-point:

Time – At this time, the luminaire shall have the brightness to be set subsequently

Light intensity (0% - 100%) – Brightness of the light at this time

If you have selected a non-dimmable luminaire, please set the following for each dimming

time:

Switch on – The light is switched on at this time

Switch off – The light is switched off at this time

Then select which simulations should affect this lighting process and save the settings with

Yes ->RETURN.

TIP

If required, you can retrofit additional 1-10 V interfaces with ProfiLux

Expansion Cards, PLM-4L or PLM 2L4S.

NOTE

The brightness curve between the individual dim-points are calculated

automatically.

Other manuals for GHL ProfiLux 4

Questions and Answers:

Need help?

Do you have a question about the GHL ProfiLux 4 and is the answer not in the manual?

General