ProfiLux 4 Programming Guide
EN 2017-02-06 79
The New numbering must only be carried out if you have connected new devices to the
DALI bus.
Assign illumination – This allows you to assign illumination to each connected DALI
device. This means that the brightness is set in the corresponding DALI device,
depending on the assigned illumination. After selecting this function, you can use
arrow up/ down to select which device you want to assign a illumination to. The
currently selected device is then operated with a brightness of 100%, all other devices
(or its associated lamps) are switched off. Confirm the selection with RETURN, then
you can Assign illumination? (arrow up/down, then RETURN again). After a short wait,
you can make another illumination assignment. When finished, press ESC.
8.12 Digital Input
If an Expansion card PLM-ADIN is available, there are 4 digital inputs as well as 2 analog
inputs. The state of a digital input can be used to directly switch a switch socket (see also
under System ->Socket outlet function) or to start or terminate a special function.
After selecting the digital input, its function can be set.
This digital input does not have any special function.
This digital input starts the automatic water change. A second switching
impulse interrupts the automatic water change.
This digital input starts the maintenance mode. A second switching
impulse terminates the maintenance mode.
This digital input starts the feeding pause. A second switching impulse
terminates the feed pause.
This digital input starts a thunderstorm.
8.13 myGHL
With the cloud-based service myGHL, we offer you an additional option for comfortably using
GHL products. To do so, you need a user account at www.myghl.com.
Before you create the account, please check whether the following prerequisites are met:
The latest firmware is installed on your ProfiLux 4. If not, perform a firmware update
(see the operating instructions).
Your ProfiLux 4 is assigned to your home network.
To Next Page
Loading...
Need help?
General
