ProfiLux 4 Programming Guide
EN 2017-02-06 50
If the temperature is below the set temperature, the operating time is increased. If the
temperature is exceeded by more than 3 °C, the substrate heater will be turned off in any
case.
The settings for the nocturnal change are taken into account.
This intelligent and elaborate process has the advantage that you always achieve the best
possible substrate circulation on your aquarium!
5.8 Therapy
(Only for temperature sensor)
If a fish disease occurs, it may be useful to change the water temperature for some time.
When the Therapy function is activated, the temperature is changed by the desired value
(reduction by 5 °C to increase by 5 °C) for the set time (3 - 21 days).
The temperature change at the beginning and end of the therapy is done gently (within one
day).
5.9 Calibration
This function is used to calibrate a sensor and the associated electronics. Please allow some
time for this. The calibration with ProfiLux 4 is simple and is menu driven. Please follow the
instructions in the display carefully.
Not all sensors can or must be calibrated (see table Calibration values below).
For all sensors that can be calibrated, the following principle applies:
Only if ProfiLux 4 has been calibrated with the connected sensor, correct values can be
determined.
ATTENTION
If you have set an upper temperature limit on the heating element for
safety reasons, you must change it if the temperature rises.
Depending on the application area of the ProfiLux 4, it may be useful to set
the measuring range before calibration of the sensors.
To Next Page
Loading...
Need help?
General
