ProfiLux 4 Programming Guide
EN 2017-02-06 32
Here you can select the 1-10V interfaces to be affected during maintenance. All non-selected
interfaces continue to operate normally and program-controlled during maintenance.
Adjust affected 1-10V interfaces
For the previously selected 1-10V interfaces, you can set here which voltage in percentage
they shall output during the maintenance.
Select affected socket outlets
Here, you can set which sockets should be influenced during maintenance. All unselected
sockets continue to operate normally and program-controlled during maintenance.
Adjust affected socket outlets
The switch state (on or off) can be set for the previously selected sockets during
maintenance.
The following two settings are available only if a Mitras Lightbar is connected.
Select affected Mitras Lightbar LEDs
Here it is possible to adjust which LEDs of Mitras Lightbar are to be influenced during
maintenance. All non-selected LEDs continue to operate normally and as programmed
during maintenance.
Adjust affected Mitras Lightbar LEDs
For the previously selected LEDs, the brightness can be adjusted as a percentage during
maintenance.
Maximum length maintenance
This time (up to 240 minutes) determines the length of time the maintenance is
automatically switched off.
The automatic shutdown after a certain period of time prevents maintenance from
remaining permanently active if you forget to switch it off again. If maintenance is allowed
for an indefinite period, enter 0 here.
Activate the Maintenance program in the Maintenance menu with Start.
While the maintenance program is active, the selected sockets have the set switching states
and the selected 1-10 V interfaces output the set voltages.
ProfiLux 4 signals an active maintenance program with a blinking hammer symbol in the
display.
End the Maintenance program from the Maintenance menu by selecting Stop.
To Next Page
Loading...
Need help?
General
