Giga-tronics 58542 - Page 125

Maintenance
Publication 21555, Rev. E, September 2002 5-7
DIAGnostic:SENS<sensor 1 or 2>:EEPROM:FREQSPecialspace double
quoteone or more frequencies 1e7 to 40e9double quote
OUTPUT @PWR_MTR;DIAG:SENS1 :EEPROM:FREQSP “1E9,2.2E9”
Add special cal factors at 1GHz and 2.2GHz
DIAGnostic:SENS<sensor 1 or 2>:EEPROM:CALFSTandard?
OUTPUT @PWR_MTR;DIAG:SENS1:EEPROM:CALFST?
Query sensor eeprom cal factor standard table
DIAGnostic:SENS<sensor 1 or 2>:EEPROM:CALFSTandardspace quote
0.20,0.30,0.40,0.50,0.60,0.70,0.80,0.90,0,0.10,0.11,0.12,0.13,0.14,
0.15,0.16,0.17,0.18quote
OUTPUT @PWR_MTR;DIAG:SENS1:CALFST
“0.20,0.30,0.40,0.50,0.60,0.70,0.80,0.90,0,0.10,0.11,0.12,0.13,0.14,0.15.0.16
,0.17,0.18”
Edit sensor 1 eeprom cal factor standard table:
2,3,4,5,6,7,8,9,10,11,12,13,14,15, 16,17,18.
Standard Cal Factor frequencies Match
Start,Step and #
DIAGnostic:SENS<sensor 1 or 2>:EEPROM:CALFSPecialspace double quote
one or more calfactor values-99.9double quote
OUTPUT @PWR_MTR;DIAG:SENS1:EEPROM:CALFSP “0.03,-0.04”
Added sensor 1 cal factors, # of items matches #
of Frequencies
DIAGnostic:SENS<sensor 1 or 2>:EEPROM:CALFSPecial?
OUTPUT @PWR_MTR;DIAG:SENS1:EEPROM:CALFSP?
Query sensor 1 special frequency cal factor
DIAGnostic:SENVoltspace<ON or OFF>
OUTPUT @PWR_MTR;DIAG:SENV ON
Turn on sensor 5 volt line
DIAGnostic:VOLT?
OUTPUT @PWR_MTR;DIAG:VOLT?
Query ADC reading in volts
DIAGnostic:ZTABle?space<sensor 1 or 2>
OUTPUT @PWR_MTR;DIAG:ZTAB? 1
Query sensor 1 zeroing data
Table 5-1: Diagnostic Commands (Continued)
Command Syntax Function