3. Fix the trap body to the mounting bracket. The spring-loaded screw should be screwed into
one of the two holes in the trap body (Fig. 4-6). Use 8 mm spanner to tighten the screw.
Figure 4.6
4. The trap can be positioned either “vertically” – trap axis is parallel to the mounting stand, or
“horizontally” – trap axis is perpendicular to the mounting stand. To change the trap
orientation, pull the trap off the mounting bracket, turn it 90 degrees and release it. The
exact trap orientation should be determined during the installation.
5. Carefully guide the trap hose that includes the coolant inlet tube, the thermocouple and the
heater cables (Fig. 4-7) through the holes in the GC oven panels. If needed, remove the
green connector from the power cable to facilitate the installation. Do not forget to mount
the connector back when the installation is finished! Tighten the connector screws!
To Next Page
Loading...