GRAPHTEC CE3000-40 - Page 64

4 – 14
Use the and keys to set the value within the range “5 mm” to “20 mm,” and then press the
(ENTER) key to confirm. To cancel, press the (NEXT) or (PREV.) key.
Press the (PAUSE) key to cancel PAUSE mode.
This automatically adjusts the distance between registration marks, rounding down to the nearest 1 mm, 5
mm, or 10 mm. For example, if the distance adjustment is set to 5 mm and the distance between the regis-
tration marks is read as 312 mm, the distance is rounded down to the nearest 5 mm and treated as a dis-
tance of 310 mm.
Press the (PAUSE) key to switch to PAUSE mode.
Press the (NEXT) or (PREV.) key until the following menu is displayed.
Press the (ENTER) key to display the Auto Reg. Mark submenu, and then press the (NEXT) or
(PREV.) key until the following menu is displayed.
Press the (ENTER) key to display the registration-mark distance-adjustment setting.
Press the or key to select “OFF,” “1 mm,” “5 mm,” or “10 mm,” and then press the (ENTER)
key to confirm. To cancel, press the (NEXT) or (PREV.) key.
Press the (PAUSE) key to cancel PAUSE mode.
Step
5
Step
6
Setting the Registration-mark Distance Adjustment
Step
1
Step
2
Step
3
Step
4
Step
5
Step
6
AUTO REG. MARK
MARK DIST. ADJ.
MARK DIST.ADJ.OFF