4 – 15
If the registration-mark origin point is not set, it will be positioned as shown in the figures below. This func-
tion should be set when it is required to move the origin point from this position.
Press the (PAUSE) key to switch to PAUSE mode.
Press the (NEXT) or (PREV.) keys until the following menu is displayed.
Press the (ENTER) key to display the Auto Reg. Mark submenu, and then press the (NEXT) or
(PREV.) key until the following menu is displayed.
Press the (ENTER) key to display the X-axis registration-mark origin input setting.
Move the cursor to the digit to be entered using the and keys, use the and keys to increase
or decrease the values (or display/don’t display “-” for the space to the right of “=”), and then press the
(ENTER) key to confirm. The Y-axis origin input setting is then displayed and should be set in the same
way. To cancel, press the (NEXT) or (PREV.) key.
Press the (PAUSE) key to cancel PAUSE mode.
Setting the Registration-mark Origin Point
Step
1
Step
2
Step
3
Step
4
Step
5
Step
6
Registration-mark pattern 1
Medium feed direction
Registration-mark pattern 2
Origin
New origin
position
Origin
X
Y
New origin
position
X
Y
X
Y
AUTO REG. MARK
MARK OFFSET
OFST X= 000.0
To Next Page
Loading...
