4 – 16
This adjusts the position of the sensor for the reading of registration marks. The adjustment crosshairs are
plotted after crosshairs already plotted have been read, and the difference between the two is input to
adjust the position.
Load a medium with the crosshairs plotted.
Set the cutter pen conditions to “PEN” (refer to “3.3 Setting the Cutter-Pen Conditions”), and mount a pen
in the cutting plotter.
Press the (PAUSE) key to switch to PAUSE mode.
Press the (NEXT) or (PREV.) key until the following menu is displayed.
Press the (ENTER) key to display the Auto Reg. Mark submenu, and then press the (NEXT) or
(PREV.) key until the following menu is displayed.
Press the (NEXT) or (PREV.) key until the following menu is displayed.
Move the cutter pen to the position of the crosshairs already plotted on the medium using the , ,
, and (POSITION) keys, and press the (ENTER) key. The sensor scans the crosshairs and
overwrites them.
Measure the offset of the crosshairs in the X-axis, and enter the distance adjustment.
Adjusting the Registration-mark Reading Sensor (1)
Step
1
Step
2
Step
3
Step
4
Step
5
Step
6
Step
7
Step
8
Medium feed
direction
Move the pen
within this area
Medium feed
direction
Newly plotted crosshairs
Crosshairs already plotted
Crosshairs already plotted
Distance adjustment X
Distance
adjustment Y
X
Y
X
Y
AUTO REG. MARK
MARK SENSOR ADJ1
MARK ADJ1 SCAN
ADJ X= 0.0
To Next Page
Loading...
