4 – 17
Move the cursor to the digit to be entered using the and keys, use the and keys to increase
or decrease the values (or display/don’t display “-” for the space to the right of “=”), and then press the
(ENTER) key to confirm. If there is no offset, simply press the (ENTER) key. The Y-axis distance-
adjustment input is then displayed and should be set in the same way. To cancel, press the (NEXT) or
(PREV.) key.
Press the (PAUSE) key to cancel PAUSE mode.
This adjusts the position of the sensor for reading the registration marks by plotting crosshairs and then
reading them. First set both cutter pen conditions 1 and 2 to the same pen. Crosshairs are first plotted
using conditions 1 and read by the sensor. A second set of adjustment crosshairs is plotted using condi-
tions 2. The difference between the two is input to adjust the position.
Load a medium into the cutting plotter.
Set both cutter pen conditions 1 and 2 to the same “Pen” (refer to “3.3 Setting the Cutter-Pen Conditions”),
and load a pen in the cutting plotter.
Press the (PAUSE) key to switch to PAUSE mode.
Press the (NEXT) or (PREV.) key until the following menu is displayed.
Press the (ENTER) key to display the Auto Reg. Mark submenu, and then press the (NEXT) or
(PREV.) key until the following menu is displayed.
Step
9
Step
10
Adjusting the Registration-mark Reading Sensor (2)
Step
1
Step
2
Step
3
Step
4
Step
5
Medium feed
direction
Adjustment crosshairs
Crosshairs first plotted
Distance adjustment X
Distance
adjustment Y
X
Y
AUTO REG. MARK
MARK SENSOR ADJ2
To Next Page
Loading...
