4 – 18
Press the (NEXT) or (PREV.) key until the following menu is displayed.
Move the cutter pen to the position for plotting of the crosshairs using the , , , and (POSI-
TION) keys, and press the (ENTER) key. The crosshairs are plotted and the following is displayed.
Press the (ENTER) key. The sensor scans the crosshairs and overwrites them.
Measure the offset of the crosshairs on the X-axis, and enter the distance adjustment.
Move the cursor to the digit to be entered using the and keys, use the and keys to increase
or decrease the values (or display/don’t display “-” for the space to the right of “=”), and then press the
(ENTER) key to confirm. If there is no offset, simply press the (ENTER) key. The Y-axis distance-
adjustment input is then displayed and should be set in the same way. To cancel, press the (NEXT) or
(PREV.) key.
Press the (PAUSE) key to cancel PAUSE mode.
Step
6
Step
7
Step
8
Step
9
Step
10
Step
11
MARK ADJ2 SCAN
PRESS ENTER KEY
ADJ X= 0.0
To Next Page
Loading...
