291
Programming examples - Using fl ight phases
Aileron differential
Brake settings
+33%
Aileron
+55%
WING MIXERS
Elevator
aileron
0%0%
–––
–––
rudder
2
3
4
5
Normal
… and enter the raised height of aileron brakes for
individual fl ight phases in the "Crow" line.
With "D.red" (differentiation reduction), you should
enter the value previously set in the aileron
differentiation line in order to suppress it again while
breaking.
In the "Elevat curve" sub-menu, enter a correction
value for the elevator, see page 150.
Note:
The "Brake settings" sub-menu of the »Wing
mixers« menu is switched "off" when: for the "Motor
at C1 front/rear" column of the »Model type« menu
(page 94) AND for the "Motor" column of the »Phase
settings« menu (page 142), a "yes" is entered for the
currently active fl ight phase. Change the fl ight phase,
if applicable.
To Next Page
Loading...
Need help?
General
