68 Detail program description - Loading a new memory location
only servos attached to receiver outputs 1 …
4 can typically be operated by the two joysticks
and that any servos attached to receiver
connectors 5 … 16 (max) will remain in their
middle positions. A newly initialized helicopter
model is also able to more-or-less move servo
6 – depending on the position of the right-side
proportional rotary slider, which is the default throttle
limiter control. With either model type, this situation
will only change after appropriate assignments have
been made in the »Control adjust« menu.
On the other hand, if a newly initialized model
memory is to be put into operation then it MUST
fi rst be appropriately "connected" with one or more
receivers before the servos attached to the receiver/s
can be operated. More about this can be found in the
section "Binding" on page 77 or 85.
A fundamental description of programming steps
for a winged aircraft model can be found in the
programming examples section beginning on 268,
or for helicopter models beginning on page 308.
The menu descriptions below are arranged in the
sequence individual menus are listed in the multi-
function list.
To Next Page
Loading...
Need help?
General
