Gyro Suppression
TRIM
Gyro Suppression
TRIM
Gyro Suppression
TRIM
Telemetry
6. THR.HOLD
This function is for powering down an engine or motor using a designated switch. Throttle hold
has higher authority than any other ight mode. When you activate THR.HOLD, the throttle
channel is driven to its programmed value. It is usually used to turn off an engine or hold in
idle position when helicopter’s auto rotation ight
In function page, touch “THR.HOLD” icon to call “THR.HOLD” setup page. Touch “INT” icon in
ACT line to switch it on and touch “NULL” icon in CTL line to call “Select” message popup.
Move the switch with your choice then that switch is designated as on/ off switch and the
switch direction setup page appears. You may select ON or OFF by touching icons. When the
switch is moved to the direction of ON, the function is operated. Touch “BACK” icon to return
to “THR.HOLD” setup page again. Touch the default value, 17%, to activate in blue and adjust
it with “INC” and “DEC” buttons. The red arrow is positioned in the setup value. When “THR.
HOLD” function is on, the green arrow is also positioned in the setup value. After setup, touch
“BACK” icon to return FUNCTION page.
Telemetry
Touch
Touch
Touch
Touch
Touch
Touch
Touch
41
To Next Page
Loading...
Need help?
General
