88
9. Flap MIX
It consists of 4 mixing types, “FLAP”, ”AILE>>FLAP”, “ELEV>>FLAP”, and “FLAP>>ELEV”.
All of 4 mixing types are closely related with Q.LINK setup and the different values can be set
to each individual Q.Link for 4 mixing types
9-1. FLAP
This function is used to adjust the ap angle to increase or decrease airplane lift
To setup the ap function, you need to designate on/off control key such as switch, stick and
volume. When you move the control key, the ap function is operated.
Touch “CH SET” in BASE page to call “CH SET” setup page. Touch “NONE” icon in FLAP 1
line to pop up “Select” message. Move the control key with your choice then that control key
is designated as on/ off key. Now, touch “SERVO” icon in the right top to call the servo view
page. The default value, 30%, for the travel amount of servo is displayed in the graph and
this function value can be adjusted. To adjust the function value, touch “Flap MIX” icon in the
function page to call Flap Mix page and touch “>>” icon in SET line to call the ap setup page.
Touch and activate the function value to adjust with INC and DEC buttons and touch “SERVO”
icon again to call the servo view page. Now, if you move the control key, you may check the
setup value of servo in this page. After setup, touch “BACK” icon to return to Flap MIX page.
REFERENCE: You may use Flap function without designating control key using OFFSET
function at the ap setup page. But the delicate ap operation is impossible.
Telemetry
Telemetry
Touch
Touch
Touch
Telemetry
Touch Touch
TouchTouch
Touch
Touch
To Next Page
Loading...
Need help?
General
