To Next Page

To Previous Page

Telemetry

14. Telemetry

It is used to perform the programming setup and check HoTT telemetry functions. Touch “Telem-

etry” icon to call the Telemetry page. You may program 5 types of “RX SELECT”, “SETTING &

DATA VIEW” “SENSOR SELECT”, ”RF STATUS VIEW”, and “VOICE TRIGGER”.

14-1. RX SELECT

It is used to select a receiver that would transmit the telemetry data to mz-24 when 2 receivers

are bound to mz-24. All of the telemetry sensors should be connected to the selected receiver.

RX1” is set in RX SELECT line as a default and “RX1” and “RX2” can be switch by touching.

Telemetry

Touch

GRAUPNER mz-18 HoTT User Manual

Other manuals for GRAUPNER mz-18 HoTT