Telemetry
1. Q.LINK
This function is used to set Q.LINK and assign all switches including sticks, switches, trim levers
and trim switches as Q.LINK selection switches to cope with various ight conditions such as 3D
ight. Since the adjusted value is activated by moving the switch and you can cope with special
tasks with switch, it makes you operating the ight much easier. Q.LINK for airplane type consists
of 8 types. (NORMAL, IDEL UP1, IDLE UP2, IDEL UP3, HOLD, Q.LINK6, Q.LINK7, Q.LINK8)
Normal type is set as a default value.
In the transmitter main page, touch “Function” icon to call the Function page and touch “Q.LINK”
icon to call Q.LINK setup page. Q.LINK list is displayed. “1.NORMAL” is the default value and it
cannot be changed.
1-1 NEW
This function is used to create new Q.LINK. Touch the value in “Q.LINK” line to activate it in blue
and touch “NEW” icon in the right to call “CTRL” and “DELAY” options. In “CTRL” setup, touch
“NULL” icon to call “Select” message popup and move the switch or stick with your choice then
the switch or stick is set to Q.LINK switch or stick. To set “DELAY” function, touch “0.0s” icon to
activate in blue and set the delay time with “INC” and “DEC” buttons. DELAY indicates the time till
Q.LINK start to work after Q.LINK is switched on
FUNCTION MENU (Airplane, Gilder)
Touch
Touch
72
Touch Touch
Touch
Touch
To Next Page
Loading...
Need help?
General
