To Next Page

To Previous Page

Touch

• MODE

It is used to select the failsafe type. “HOLD” is basically set in all the channels.

Touch “SET” icon to activate the value in red then you may select HOLD or OFF or FAIL SAFE

with INC and DEC buttons. After selecting one of HOLD, OFF and FAIL SAFE, touch “SET”

icon again to deactivate the value. Touch INC button to move the cursor to “F.S.POS”

•

F.S.POS

It is used to decide the servo’s position when FAIL SAFE function is activated.

Touch “SET” icon to activate the value in red and adjust the value with INC and DEC buttons.

Touch “SET” icon again to deactivate the value. Touch INC button to move the cursor to “DELAY”

Touch INC button to move the cursor to “INPUT CH” and touch “SET” icon to activate the

value in red then select the channel to be connected to “OUTPUT CH” with INC and DEC

buttons. Touch “SET” icon again to deactivate the value. Touch INC button to move the cursor

to “MODE”

Touch

GRAUPNER mz-24 HOTT Operating Instructions

Other manuals for GRAUPNER mz-24 HOTT