Touch
Touch
Touch
Touch
Touch
54
Touch
Touch
Touch
Touch
•
PERIOD
It is used to set the speed of receiver’s output signal.
Touch “SET” icon to activate the default value, 20msec, in red and set the value to 10msec
with INC and DEC buttons. Touch “SET” icon again to deactivate the value and touch ENT
button to call “RX FAIL SAFE” setup page
- RX FAIL SAFE
• OUTPUT CH/ INPUT CH
You may edit and adjust transmitter channel which is connected with a receiver using “OUT-
PUT CH” and “INPUT CH”. Receiver CH1, 2, 3, 4, 5, 6 are connected to the same channels of
transmitter as the default and you may edit the channel connection of receiver and transmitter.
Since OUTPUT CH is changed if INPUT CH would be changed, we recommend that you
would change INPUT CH.
To Next Page
Loading...
Need help?
General
