Grundfos TPE2 - Page 41

Settings
TPE3
TPE3 D
TPE2
TPE2 D
Multipump
system
Section
"Analog output" ● ● - 17.16 Analog output
"External setpoint funct." ● ● -
17.19 External setpoint
function
"Signal relay 1" ● ● -
17.15 "Signal relays 1 and 2"
(Relay outputs)
"Signal relay 2" ● ● -
"Limit 1 exceeded" ● ● ●
17.22 Limit-exceeded
function
"Limit 2 exceeded" ● ● ●
"Alternating operation, time" - -
●
1)
"Multipump setup" (Setup of
multi-pump system)
"Time for pump changeover" - -
●
1)
"Standstill heating" ● ● - Standstill heating
"Motor bearing monitoring" ● ● -
17.26 Motor bearing
monitoring
"Service" ● ● - "Service"
"Store settings" ● ● -
"Store settings" (Store actual
settings)
"Recall settings" ● ●
"Recall settings" (Recall stored
settings)
"Undo" ● ● ● "Undo"
"Pump name" ● ● ● "Pump name"
"Connection code" ● ● ● "Connection code"
"Unit configuration" ● ● ● 17.32 Unit configuration (Units)
Alarms and warnings
TPE3
TPE3 D
TPE2
TPE2 D
Multipump
system
Section
"Alarm log" ● ● ● Alarm log
"Warning log" ● ● ● Warning log
"Reset alarm" button ● ● ●
Assist
TPE3
TPE3 D
TPE2
TPE2 D
Multipump
system
Section
"Assisted pump setup" ● ● Assisted pump setup
"Assisted fault advice" ● ● ● Assisted fault advice
"Multipump setup" ● ● ●
"Multipump setup" (Setup of
multi-pump system)
41
English (GB)