Grundfos TPE2 - Page 40

Status
TPE3
TPE3 D
TPE2
TPE2 D
Multipump
system
Section
"Pump 2" - -
●
1)
"Pump 3" - -
●
1)
"Pump 4" - -
●
1)
1)
Only available if Grundfos GO is connected to a multipump system.
Settings
TPE3
TPE3 D
TPE2
TPE2 D
Multipump
system
Section
"Setpoint" ● ● ● Setpoint
"Operating mode" ● ● ● 17.3 Operating mode
"Set user-defined speed" ● ● ● 17.5 User-defined speed
"Control mode" ● ● ● 17.6 Control mode
"Proportional-pressure setup" ● - - Proportional-pressure setup
"Date and time" ● ● ●
17.31 Date and time (Set date
and time)
"Flow limit" ● - ● 17.8 FLOWLIMIT
"Automatic Night Setback" ● - ●
17.9 Automatic Night
Setback
"Temperature influence" ● - ● 17.21 Temperature influence
"Buttons on product" ● ● ●
17.33 "Buttons on product"
(Enable/disable settings)
"Controller" ● ● ●
17.17 Controller (Controller
settings)
"Operating range" ● ● ● Operating range
"Ramps" ● ● 17.24 Ramps
"Pump number" ● ● - Number (Pump number)
"Radio communication" ● ● -
Radio communication (Enable/
disable radio comm.)
"Analog input 1" ● ● -
17.10 Analog inputs
"Analog input 2" ● ● -
"Analog input 3" ● ● -
"Built-in Grundfos sensor" ● - ●
17.11 Built-in Grundfos
sensor
"Pt100/1000 input 1" ● ● -
17.12 Pt100/1000 inputs
"Pt100/1000 input 2" ● ● -
"Digital input 1" ● ● -
17.13 Digital inputs
"Digital input 2" ● ● -
"Digital in/output 3" ● ● -
17.14 Digital inputs/outputs
"Digital in/output 4" ● ● -
"Predefined setpoint" ● ● ● Predefined setpoints
40
English (GB)