272 Cycles: Coordinate Transformations
11.1 Fundamentals
11.1 Fundamentals
Overview
Once a contour has been programmed, you can position it on the
workpiece at various locations and in different sizes through the use
of coordinate transformations. The TNC provides the following
coordinate transformation cycles:
Cycle Soft key Page
7 DATUM SHIFT
For shifting contours directly within the
program or from datum tables
Page 274
247 DATUM SETTING
Datum setting during program run
Page 281
8 MIRROR IMAGE
Mirroring contours
Page 282
10 ROTATION
For rotating contours in the working
plane
Page 284
11 SCALING FACTOR
For increasing or reducing the size of
contours
Page 286
26 AXIS-SPECIFIC SCALING FACTOR
For increasing or reducing the size of
contours with scaling factors for each
axis
Page 288
19 WORKING PLANE
Machining in tilted coordinate system on
machines with swivel heads and/or
rotary tables
Page 290
To Next Page
Loading...
Need help?
General
