HEIDENHAIN ITNC 530 - CYCLE PROGRAMMING User Manual

HEIDENHAIN iTNC 530 273
11.1 Fundamentals
Effect of coordinate transformations
Beginning of effect: A coordinate transformation becomes effective as
soon as it is defined—it is not called. It remains in effect until it is
changed or canceled.
To cancel coordinate transformations:
 Define cycles for basic behavior with a new value, such as scaling
factor 1.0
 Execute a miscellaneous function M2, M30, or an END PGM block
(depending on MP7300).
 Select a new program
 Program miscellaneous function M142 "Erasing modal program
information".

HEIDENHAIN ITNC 530 - CYCLE PROGRAMMING Specifications

General

Brand	HEIDENHAIN
Model	ITNC 530 - CYCLE PROGRAMMING
Category	Control Panel
Language	English