Why am I experiencing time loss with my HellermannTyton Autotool 2000 CPK Tools?
If your HellermannTyton Tools are experiencing time loss, the back-up battery for the clock in the power pack has likely discharged. Change the back-up battery.
What to do if the HellermannTyton Tools cable tie reel will not unwind?
If your HellermannTyton Tools cable tie reel won't unwind, it's likely that the cable tie reel was inserted incorrectly. To resolve this, ensure you insert the cable tie reel with the clockwise winding direction.
What to do if material waste is not being properly disposed of in HellermannTyton Industrial Equipment?
If the material waste from your HellermannTyton Industrial Equipment isn't being disposed of properly, it might be due to a full waste bin. Empty the waste bin. Alternatively, the opening in the base plate could be blocked. Inspect the opening from below for any blockages and remove the material waste.
Why won't the cable tie reel unwind in my HellermannTyton Industrial Equipment?
If the cable tie reel of your HellermannTyton Industrial Equipment won't unwind, check the winding direction. If the cable tie reel is inserted in the wrong winding direction (clockwise) insert it with counterclockwise winding direction. Also, the reel brake might be set too strong. Reduce the braking force of the reel brake.
What to do if the HellermannTyton Power Tool shows 'Error, gate Close gate'?
If the HellermannTyton Power Tool displays the error message 'Error, gate Close gate', it means the gate is open. To resolve this, simply close the gate.
Why does the HellermannTyton Power Tool display 'Error, front cap Remove cable-tie residues'?
The 'Error, front cap Remove cable-tie residues' message on your HellermannTyton Power Tool indicates that cable tie residues are trapped behind the front cap, causing the front sensor to be busy. Clear the front sensor and carefully remove any cable-tie residues.
What to do if HellermannTyton Power Tool displays 'Error, start position'?
The 'Error, start position' message on the HellermannTyton Power Tool means it is not in the start position. Try the following: * Push the trigger for the bandoleer cutter to the left and open the gate. * Remove any cable-tie residues and press the Reset button. * Close the gate.
What to do if the HellermannTyton Power Tool shows 'Overload'?
If your HellermannTyton Power Tool displays 'Overload', it indicates that the drum is blocked or the cable tie is not cut off. You can: * Push the trigger for the bandoleer cutter to the left and open the gate. * Remove any cable-tie residues and press the Reset button.
General| Type | Autotool 2000 CPK |
|---|---|
| Application Method | Pneumatic |
| For Cable Diameter Max. | 20 mm |
| Bundling Diameter max. | 20 mm |
| Tensile Strength min. | 80 N |
| Tensioning | Automatic |
| Tension Force | Adjustable |
| Tie Width | 4.5 mm |
| Cable Tie Width | 4.5 mm |
| Material Shortcut | PA66 |
| Operating Temperature | -40°C to +85°C |
| Tool Included | Yes |
| Pack Quantity | 1 |
| Cutting Mechanism | Automatic |
| Cutting System | Flush cut |
| Power Supply | Pneumatic |
| Operating Pressure | 6 bar |
| Material | Nylon 6.6 |
To Next Page
