Heras HMD Basic - Page 67

EN – Translation of the original user manual - 2.0 | 2019
67
Reference/
Error no.
Text
Meaning
143
Auto.Closing-
run ON
------- ?
After a restart of the program, the gate is in the
OPEN position and awaits the activation of the
closing-run timer
161
Immediate stop
The stop function is activated for longer than 2
seconds (STOP input or hold-to-run OPEN and
CLOSE are active at the same time). This is only
entered in the system log when activated with
the motor running
171
OPEN
The OPEN limit switch was activated during the
OPEN movement and deactivated again before
the motor had come to a halt
172
CLOSE
The CLOSE limit switch was activated during the
OPEN movement and deactivated again before
the motor had come to a halt
197
START
Restart of the program
201
ROM error
The motor controller has detected a program
memory error (fatal exception error)
202
EEPROM Bcc
An error occurred when accessing the EEPROM
(may occur sporadically after reset, e.g. if menu
was not correctly exited)
203
StackReg.err
The motor controller has detected a stack
registry error (fatal exception error)
204
Stack.err:low
The motor controller has detected a stack
registry error (fatal exception error)
205
Stack.err:high
The motor controller has detected a stack
registry error (fatal exception error)
206
Watchdog.err:low
The motor controller has detected a watchdog
error (fatal exception error)
207
Watchdog.err:high
The motor controller has detected a watchdog
error (fatal exception error)
208
Watchdog error
The motor controller has detected a watchdog
error (fatal exception error)
209
WDG Reset
The motor controller was restarted by the
watchdog