EN ā Translation of the original user manual - 2.0 | 2019
The voltage monitoring system for the release
signal has measured an excessively high value
for the idle voltage
The test current at the DC power module is too
high
The test current at the DC power module is too
low
The DC power module has detected an
excessively high motor current
Incremental sensor value in OPEN direction too
low
Incremental sensor values in CLOSE direction too
low
A reference movement of the gate was activated
The program start of the motor controller was
interrupted due to an active movement command
(Check inputs)
The light barrier test has shown up an error
The self-test failed at the emergency input
A checksum error occurred during
communication between the controllers
A data error was detected during communication
between the controllers
An error occurred when writing data into the
memory
The self-test on the EMERGENCY STOP input
failed
The loaded parameter set and the program
variant of the controller do not match
An error was detected when transferring the
parameter set from the periphery controller to
the motor controller (CRC16 checksum)
Menu program pointer error
(Error in menu structure branching)
In system log: The program was initialised
(deletion and initialisation of the parameter
memory)
To Next Page
Loading...
