HIKVISION DS-7608NI-M2 Series User Manual

Figure 13-5 Port Sengs
2. Congure port sengs as needed.
Alarm Host IP/Port
With a remote alarm host congured, the device will send the alarm event or excepon
message to the host when an alarm is triggered. The remote alarm host must have the client
management system (CMS) soware installed. The alarm host IP refers to the IP address of
the remote PC on which the CMS
soware (e.g., iVMS-4200) is installed, and the alarm host
port (7200 by default) must be the same as the alarm monitoring port congured in the
soware.
Server Port
Server port (8000 by default) should be congured for remote client soware access and its
valid range is 2000 to 65535.
HTTP Port
HTTP port (80 by default) should be congured for remote Web browser access.
Mulcast IP
Mulcast can be congured to enable Live View for cameras that exceed the maximum
number allowed through network. Both IPv4 and IPv6 are available for
mulcast IP address.
For IPv4, it covers Class-D IP ranging from 224.0.0.0 to 239.255.255.255 and it is
recommended to use an IP address ranging from 239.252.0.0 to 239.255.255.255. When
adding a device to the CMS
soware, the mulcast address must be the same as that of the
device.
Network Video Recorder User Manual
117

HIKVISION DS-7608NI-M2 Series Specifications

General

Brand	HIKVISION
Model	DS-7608NI-M2 Series
Category	Network Hardware
Language	English