HIKVISION DS-7608NI-M2 Series User Manual

Figure 6-7 Region Entrance Detecon
4. Check Enable Region Entrance Detecon.
5. Oponal: Check Save VCA Picture to save the captured pictures of region entrance detecon
pictures.
6. Set detecon rules and detecon areas.
1) Select Arming Region.
Note
Up to 4 regions are selectable.
2) Set Sensivity.
Sensivity
The higher the value is, the easier the detecon alarm will be triggered. Its range is [0-100].
3) Click Draw Region, and draw a quadrilateral in the preview window.
7.
Oponal: Draw the maximum size/minimum size for targets. Only the targets in the size ranging
from maximum size to minimum size will trigger line crossing detecon.
1) Click Max. Size/Min. Size.
2) Draw an area in preview window.
3) Click Stop Drawing.
8.
Oponal: Select Detecon Target as Human or Vehicle to discard alarms which are not triggered
by human body or vehicle.
9. Set the arming schedule. Refer to
Congure Arming Schedule .
10. Set linkage
acons. Refer to Congure Linkage Acons .
11. Click Apply.
6.2.8 Region
Exing Detecon
Region exing detecon detects objects that exit from a predened virtual region.
Network Video Recorder User Manual
58

HIKVISION DS-7608NI-M2 Series Specifications

General

Brand	HIKVISION
Model	DS-7608NI-M2 Series
Category	Network Hardware
Language	English