HIKVISION DS-7608NI-M2 Series - Loitering Detection

Note
a. If there are parts of the screen (either within or outside the detecon area) that do not
need to be detected (such as an area where the light jumps from me to me or leaves
oen dri by and trigger false alarms, etc.), you can draw it as a shield region.
b. Click
to start drawing, le click each me on the screen to determine a vertex, right click
to stop drawing. The inside of the drawn polygon is the shielded area. If you make a mistake,
you can click and redraw.
c. 8 shield regions are supported.
11. Click Save.
6.2.12 Loitering Detecon
Loitering detecon is used to detect whether a target stays within a specied area longer than the
set
me and trigger alarm for linked acons.
Steps
1. Go to Smart Analysis → Smart Event Sengs → Other Events .
2. Select a camera.
3. Click Loitering
Detecon.
Figure 6-9 Loitering Detecon
4. Check Enable Loitering Detecon.
5. Oponal: Check Save VCA Picture to save the captured loitering detecon pictures.
6. Set loitering
detecon parameters.
1) Select Arming Area.
Network Video Recorder User Manual
62