HIKVISION DS-7608NI-M2 Series User Manual

6.5.3 Nofy Surveillance Center
The device can send an excepon or alarm signal to the remote alarm host when an event occurs.
The alarm host refers to the PC installed with client
soware (e.g., iVMS-4200, iVMS-5200).
Steps
1. Go to System → Network → Advanced → More Sengs .
2. Set the alarm host IP and alarm host port.
3. Go to Linkage
Acon interface of the alarm detecon (e.g., moon detecon, video tampering,
face detecon, etc.).
4. Select Nofy Surveillance Center.
6.5.4
Congure Email Linkage
The system can send an email with alarm informaon to a user or users when an alarm is detected.
Steps
1. Go to System → Network → Advanced → Email .
2. Set the email parameters.
3. Click Apply.
4. Go to the Linkage
Acon interface of the alarm detecon (e.g., moon detecon, video
tampering, face
detecon, etc.).
5. Select Send Email alarm linkage acon.
6.5.5
Congure Audio Alert
When an alarm is triggered, an audio le will be played as the linkage acon. The audio le can be
customized. Refer to Audio Management for details.
Before You Start
Ensure the audio les are imported to the device.
Steps
Note
This linkage acon is only available for certain events.
1. Check Audio Alert in Normal Linkage.
2. Click
to select audio le.
3. Select an audio le.
4. Set arming schedule.
5. Click OK.
6. Click Apply.
Network Video Recorder User Manual
76

HIKVISION DS-7608NI-M2 Series Specifications

General

Brand	HIKVISION
Model	DS-7608NI-M2 Series
Category	Network Hardware
Language	English