HIKVISION DS-7608NI-M2 Series - Chapter 14 POS Configuration; Configure POS Connection

Chapter 14 POS Conguraon
The device can be connected to a POS machine/server, and receive a transacon message to
overlay on the image during Live View or playback, as well as trigger a POS event alarm.
14.1 Congure POS Connecon
Steps
1. Go to System → POS .
2. Click Add.
Figure 14-1 POS Sengs
3. Select a POS device from the drop-down list.
4. Check Enable.
Note
The number of POS devices supported by each device is the half of its number of channel, e.g., 8
POS devices are supported for the DS-9616NI-I8 model.
5. Select POS Protocol.
Note
When a new protocol is selected, reboot the device to acvate the new sengs.
Universal Protocol
Click Advanced to expand more sengs when selecng the universal protocol. You can set
the start line
idener, line break tag, and end line tag for the POS overlay characters, and
the case-sensive property of the characters. You can also oponally check the ltering
idener and the XML protocol.
Network Video Recorder User Manual
119