HIKVISION DS-7608NI-M2 Series User Manual

Steps
1. Go to System → System Service → System Service .
Figure 16-22 RTSP Authencaon
2. Select RTSP Authencaon Type.
Note
Two authencaon types are selectable, if you select digest, only the request with digest
authencaon can access the video stream by the RTSP protocol via the IP address. For security
reasons, it is recommended to select digest as the authencaon type.
3. Click Apply.
4. Restart the device to take eect the sengs.
16.12.4 RTSP Digest Algorithm
RTSP digest algorithm is based on RTSP protocol, it is an algorithm for digest authencaon of the
user
authencaon. You can congure RTSP digest algorithm via web browser.
Go to Conguraon → System → Security → Authencaon via web browser to select the
required RTSP digest algorithm type.
16.12.5 ISAPI Service
ISAPI (Internet Server Applicaon Programming Interface) is an open protocol based on HTTP,
which can realize the
communicaon between the system devices (e.g., network camera, NVR,
etc.). The device is as a server, the system can nd and connect the device.
Steps
1. Go to System → System Service → System Service .
2. Check Enable ISAPI.
3. Click Apply.
4. Restart the device to take
eect the sengs.
16.12.6 HTTP
Authencaon
If you need to enable the HTTP service, you can set HTTP authencaon to enhance access
security.
Steps
1. Go to Maintenance → System Service → System Service .
Network Video Recorder User Manual
154

HIKVISION DS-7608NI-M2 Series Specifications

General

Brand	HIKVISION
Model	DS-7608NI-M2 Series
Category	Network Hardware
Language	English