5.2 Alarm Output
110
Some alarm settings are available on the Waveform/Numerical screens.
On the [Gauge+Wave] Waveform/Numerical screen, the alarm beeper, alarm hold, and
[ALARM CLR] (when alarm hold is enabled) can be set. (Alarm hold can only be set
when measurement is stopped.)
Hold
Selects whether to reset or hold (latch) alarm outputs while measuring. (can only
be set when measurement is stopped)
Buzzer (beeper)
Enables and disables the alarm beeper. (can be set while measuring or not)
ALARM CLR
When alarm hold is enabled, put the cursor here and press ENTER to clear the
alarm manually.
An alarm can be cleared only when the alarm criteria are no longer met.
Select the [Gauge+Wave] Wave-
form/Numerical screen.
Select [PLS & ALM] with the UNIT
key.
Put the cursor here and press ENTER to
directly select which input unit to display.
1
2
To Next Page
Loading...
