12.1 Inspection, Repair, and Cleaning
243
3
12
Chapter 12 Maintenance and Service
Replaceable Parts and Operating Lifetimes
Useful life depends on the operating environment and frequency of use. Operation can-
not be guaranteed beyond the following periods.
For replacement parts, contact your dealer or Hioki representative.
Fuse
The fuse is housed in the power unit of the HiLogger. If the power does not turn on, the
fuse may be blown. If this occurs, a replacement or repair cannot be performed by cus-
tomers. Please contact your dealer or Hioki representative.
Cleaning
To clean the HiLogger, wipe it gently with a soft cloth moistened with water or mild deter-
gent. Never use solvents such as benzene, alcohol, acetone, ether, ketones, thinners or
gasoline, as they can deform and discolor the case. And, wipe the LCD gently with a soft,
dry cloth.
Maintenance and
Service
Chapter 12
12.1 Inspection, Repair, and Cleaning
Touching any of the high-voltage points inside the HiLogger is very
dangerous.
Do not attempt to modify, disassemble or rep
air the HiLogger; as fire,
electric shock and injury could result.
Part Life
LCD (to half brightness)
Approx. 40,000 hours
Z1000 Battery Pack
Battery charge capacity is reduced to about 60% after 300 full charge/dis-
charge cycles.
Battery pack connector
Connect/disconnect 30 times (for stable contacts)
Electrolytic Capacitors
Approx. 10 years
Lithium battery
Approx. 5 years
The HiLogger contains a built-in backup lithium battery. If the date and
time deviate substantially when the HiLogger is switched on, it is the time
to replace that battery. Contact your dealer or Hioki representative.
Transporting
• Use the original packing materials when transporting the HiLogger, if pos-
sible.
• Pack the HiLogger so that it will not sustain damage during shipping, and
includ
e a description of existing damage. We do not take any responsibil-
ity for damage incurred during shipping.
To Next Page
Loading...
