Hioki LR8401-20 - E-Mail Sending Authentication

10.7 Sending E-Mail
222
The HiLogger supports "POP before SMTP" and "SMTP" for mail sending authentication.
Set as needed.
The SMTP authentication is available in the firmware version 1.27 or later.
E-Mail Sending Authentication
Increment/decrement by 1
Increment/decrement by 10
Numerical Settings
Character Settings
See: 
"3.7 Entering Titles and Comments
(as needed)" (p. 71)
1 Mail Authentication
OFF No authentication
POP Auth Employs POP before
SMTP
Set Server Name, IP/Port,
Account Name, Password.
SMTP Auth Employs SMTP 
(supporting PLAIN and
LIGIN)
Account Name, Password.
2 Enter the [Server Name(POP)].
Enter the name of the POP3 server.
3 Set the [IP / Port(POP)].
Set the POP3 server's IP address and
port number.
4 Enter the [Account Name].
Enter the name of the user account for
authentication.
5 Enter a [Password].
Enter the password for authentication.
The password is displayed as "***...***”
(32
asterisks (*)).
Setting options:
Up to 32 characters.
Setting options:
IP Address _._._._ (where _ is 0 to 255)
Port No. 0 to 65535 (Default setting:
110
)
Setting options:
Up to 32 characters.
Setting options:
Up to 32 characters.
2
3
4
5
1