Hioki LR8401-20 - Trigger Setting Examples

5.6 Trigger Setting Examples
119
3
5
Chapter 5 Specifying Criteria for Measurements
Following are examples of typical trigger settings.
5.6 Trigger Setting Examples
Intended Measurement Objective
Ref. No.
(next table)
Acquire data from when you press START until you press STOP
No.1
Acquire data for one minute after each time you press
START
No.2
Acquire data at one-minute intervals for sixty minutes after you press START
No.3
When the temperature measured on CH1 exceeds 500C, acquire data until you press
STOP.
No.4
Acquire data from when you press START until the temperature measured on CH1 exceeds
500
C.
No.5
Acquire data from when the temperature measured on CH1 exceeds 500C until it drops
be
low 300C.
No.6
Acquire data whenever the temperature measured on CH1 exceeds 500C, until it drops
below 300
C.
No.7
Acquire data for only one minute from when the temperature measured on CH1 exceeds
50
0C.
No.8
Acquire data for one minute before and after the time when the temperature measured on
CH1 exceeds 500
C.
No.9
Acquire data from 9:00 to 17:00 on 6/17/2008.
No.10
Starting at 9:00 on 6/17/2008, acquire data for 24 hours/day, for one month. No.11
Starting on 6/17/2008, acquire data continuously fro
m 9:00 to 17:00 daily for one month. No.12
Starting on 6/17/2008, acquire data for one hour at 9:00, 15:00, 21:00, and 3:00 daily for one
month.
No.13