on.
Right side
Turn the power
switch on ( ).
The power supply icon ap-
pears near the bottom right
corner of the screen (p. 20).
If the " " indicator is not displayed, the HiLogger is not being powered from
the AC line. In this state, the battery charge will be depleted if measuring for a
long time, and measurement may be interrupted. Verify that the AC adapter is
securely connected to an AC power source and to the HiLogger.
Turning Power On
Turn the power switch off ( ).
The installed battery pack is charged whenever the AC adapter is
plugged into a power outlet, even when the Memory HiLogger is off.
Verify that the HiLogger and peripheral
devices are correctly connected.
Turning Power Off
Perform zero adjustment as needed after 30 minutes warm-up (p. 48).
Initial screen
To Next Page
Loading...
