Hioki LR8401-20 - Displaying Gauges

4.2 Observing Waveforms
86
A gauge corresponding to the measurement range of each channel can
be displayed at the left side of the screen, for confirming measurement
values.The color of the gauge matches the waveform display color of its
input channel. Channel settings can also be changed.
Move to a setting item.
Apply
Open the setting options
for the item to be set.
Select from the listed op-
tions
Key Setting Procedure
Displaying Gauges
Gauge
 Display area settings
Display position (p. 66)
Upper and lower dis-
play limits (p. 67)
You can switch between
channel settings and
event search settings.
 Event Search (p. 93)
Select [Gauge+Wave].
About Channel Settings
Press CHAN to select channels for gauge display.
However, note that when measurement data is displayed, only those channels that are en-
abled (set to On ) for measurement can be selected.
When starting measurement with all channels disabled (Off), CH1-1 (only) is automatically
enabled.
 Voltage measurement (p. 55)
 Temperature measurement 
(Thermocouple) (p. 56)
 Temperature measurement (RTD)
(p. 58)
 Humidity measurement (p. 59)
 Resistance Measurement (p. 60)
 Pulse/Logic Measurement (p. 61)
 Integration (pulse count) (p. 62)
 Revolution measurement (p. 63)
 Select the alarm display type 
(p. 109)
 Waveform Calculation (p. 149)