Hioki LR8401-20 - Initializing Settings (to Factory Defaults)

3.9 Viewing and Editing with the All-Channel Settings List
77
3
3
Chapter 3 Settings
Certain settings in all input units (or a selected input unit) can be reset to their factory
default state.
Initializing Settings (to factory defaults)
Select [Batch Proc].
1
3
Apply
The selected items are displayed.
4
Select the desired action.
The actions that can be selected
depend on the display screen
(see below).
Apply
Select a unit.
2
 [Range] Screen
• [Initialize all the range settings of all units shown on screen.]
Resets the range screen settings of all input units.
• [Initialize all the settings of this unit shown on screen.]
Resets the range screen settings of the selected input unit.
 [Conv/Calc] Screen
• [Initialize all the scaling settings of all units.]
Resets the scaling settings of all input units.
• [Initialize all the waveform calculation settings of all units.]
Resets the waveform calculation settings of all input units.
• [Initialize all the settings of this unit shown on screen.]
Resets the conversion/calculation settings of the selected input unit.
 [Trig & Alm] Screen
• [Initialize all the trigger/alarm settings of all units on screen.]
Resets the [Trig & Alm] screen settings of all input units.
• [Initialize all the settings of this unit shown on screen.]
Resets the [Trig & Alm] screen settings of the selected input unit.
Select which screen you
want to initialize, from the
[Range], [Conv/Calc], [Trig
& Alm] screens.