5.2 Alarm Output
113
3
5
Chapter 5 Specifying Criteria for Measurements
An alarm can be output when thermocouple burn-out is detected.
Setting options: ( : default setting)
OR
Alarm output occurs when the alarm criteria
specified for any alarm-enabled channel are
satisfied.
AND Alarm output occurs only when the alarm crite-
ria for every alarm-enabled channel are satis-
fied.
3. Selecting Combined Alarm Output Criteria
Select the [Trig & Alm] Screen.
If [Alarm] is set to [Off],
change it to ([On]).
1 Select the [Trig & Alm] Screen.
2 Select a [Pulse Logic Alarm] unit.
3 Set [Alarm at burn out. ] to [On].
This setting causes alarm output to be generated whenever a broken wire is detected,
regardless of other alarm condition settings and alarm source settings [AND, OR].
1
2
3
To Next Page
Loading...
