Hioki RM3545-02 - Page 190

10.1 External Input/Output Connector and Signals
182
JUDGE mode and BCD mode
Output signals operate under either JUDGE mode or BCD mode. The JUDGE mode output
signals vary depending on whether the multiplexer is being used. In BCD mode, signals are
used for both the upper and lower digits (and range information).
See: "Switching Output Modes (JUDGE Mode/ BCD Mode)" (p. 214)
Pin functions in JUDGE mode
Pin functions in BCD mode
The BCD upper digits and lower digits (and range information) are switched using the
BCD_LOW signal.
Pin
BCD_LOW (2pin)
Pin
BCD_LOW (2pin)
OFF ON OFF ON
9 ISO_COM 28 EOM
10 ERR 29 BCD4-0 RNG_OUT0
11 HILO 30 IN
12 BCD4-1 RNG_OUT1 31 BCD4-2 RNG_OUT2
13 BCD4-3 RNG_OUT3 32 BCD5-0 BCD1-0
14 BCD5-1 BCD1-1 33 BCD5-2 BCD1-2
15 BCD5-3 BCD1-3 34 BCD6-0 BCD2-0
16 BCD6-1 BCD2-1 35 BCD6-2 BCD2-2
17 BCD6-3 BCD2-3 36 BCD7-0 BCD3-0
18 BCD7-1 BCD3-1 37 BCD7-2 BCD3-2
19 BCD7-3 BCD3-3
(When the multiplexer is not being used)
Pin Function Pin Function
9 ISO_COM 28 EOM
10 ERR 29 INDEX
11 HI 30 IN
12 LO 31 OB
13 BIN0 32 BIN1
14 BIN2 33 BIN3
15 BIN4 34 BIN5
16 BIN6 35 BIN7
17 BIN8 36 BIN9
18 OUT0 37 OUT1
19 OUT2
(When the multiplexer is being used)
Pin Function Pin Function
9 ISO_COM 28 EOM
10 ERR 29 INDEX
11 HI 30 IN
12 LO 31
−
13 T_PASS 32 T_FAIL
14 T_ERR 33
−
15 − 34
−
16
−
35
−
17
−
36
−
18 OUT0 37 OUT1
19 OUT2